Forging a cut-off hardie

I forged a cut-off hardie a while back. I took some pictures along the way. I hope you enjoy.

I used an ax wedged into a stump as a cut-off for a long time, but it’s time for an upgrade.
I used an ax and sledge to cut the end off the jack hammer bit.
I forged the hardie section down some.
The jack hammer bit I forged down.
This only took a few heats.
Before I evened out the edge and sharpened it with a file.
After the file work.
After I let it normalize I heated the cut-off and then quenched it in oil.
I then immediately tempered to a golden straw.
I tempered it in the oven again, twice: once after fire tempering, and once the next day.

I’ve been working on creating some extra pages for my blog. I can’t wait to publish them.