St. George’s Day demo

I had a grand time helping out Solvar at the St. George’s Day demonstration at Lafayette Village.
I even got to display and vend some stuffs from the forge.

Several leaf and hart key chains.
Several leaf and heart key chains.
Rose paper weights.
Rose paper weights.
A tripod with hooks for cooking or flower pots close up on the hooks
A tripod with hooks for cooking or flower pots close up on the hooks
A tripod with hooks for cooking or flower pots
A tripod with hooks for cooking or flower pots
S-hooks and a heart horseshoe wall mount.
S-hooks and a heart horseshoe wall mount and a few j-hooks.
Some fire place tools were there for display only.
Some fire-place tools already sold were there for display only.

A flower candleholder wall hook

I made this flower candle holder and wall hook not so long ago. Here’s how:
I started by forging a leaf out on the end of a piece of flatbar
I then forge welded about 21″ of the bar stock over onto itself. I tapered the end and cut a small indent close to halfway to prepare for the next weld.
I folded it over once again and forge welded it.
After welding was complete I started to form a fishtail with the crosspein.
The bar is now about 1/2″x1/2″ and I still needed to punch a hole and trim the fishtail with a chisels (not photoed)
The bar was then folded and welded for a third time. This is a bit more time-consuming than jump welding smaller stock to a 1/2″x1/2″ base would be I imagine, but the finished product would look different.
I forged the hook and I can start shaping the stem to the flower. When bending the hook I noticed it was about 20 degree off horizontally when mounted flat on the wall. Instead of straightening it out and redoing it I just twisted it to the right angle. This gave an undesirable line that I refined later.
The bulk of the work is done.
This isn’t an occult blacksmithing ritual. I cut out a small semi-circle for the flower and drew a star to mark the pedals.
I used snips and a punch to form the flower. It took a little sanding too.
Rose candle hook 11
A crosspein on a stump gave the pedals texture.
rose candle hook 12
I cut off the excess stem and bent it around to secure the flower. (You can also see a steak turner I made a while before I could finish the hook and candle holder).
These little scented candles come with a thin metal pan that I glued into the center of the flower using JB-weld.

I’ll get a better picture of it mounted sometime soon I hope.
I’ve got some more projects to post eventually and some more how-to stuff too.
(update)
1119121118a
–Greg

So hot steel leaves wilt

It’s been darn near a hundred in the shade lately. But I’ve been trying to stay hydrated by the forge. I’ve been practicing leaves. And well I have some more stuff for the ugly side of my next installment the good, bad and the ugly. But I liked these from the other day:

hand forged leaf hooks

 

leaf hook start
leaf hook start

 

leaf hook fire welded
leaf hook forge welded

 

leaf hook hole prep
leaf hook punch prep
leaf, ballpein, tongs, holdfast
leaf hook punch
hand forging leaf hooks
leaf hooks in the works

–Greg